Academic UPNM
A training was held in UPNM on Multisim and Ultiboard, the training was to design Schematic circuit and PCB layout. The training taught Schematic diagram for simple circuit – LED and buzzer. Schematic diagram for intermediate circuit – Digital Electronics (D, J-K and CLK flip flop, half and full adder, half and full subtractor and CMOS). Schematic diagram for intermediate circuit – Analog Electronics (Half-wave and Full-wave rectifier, Inverting and Non-Inverting Op Amp) and PCB design for 5V voltage regulator using LM 9805
Pinang KKSBJ, Hardware and Programming training
The training was taken places in KKSBJ, Pulau Pinang. The training had 3 Module to taught so then the modules were getting started with NI myDAQ – Data Acquisition (DAQ) of digital and analog sensor, getting started with NI ELVIS – Using Function Generator (FGEN) and Oscilloscope to display sensor signals and getting started with NI myRIO – DAQ in Real-Time (RT) using embedded Linux OS on controller.
LabVIEW Fundamental (UNIKL MIAT)
Basic environmental training in LabVIEW.
One of our engineer presented a training on LabVIEW Fundamental in UNIKL MIAT. The training taught from basic in details from explaining the introduction software until starting to use the software. Mostly the basic training were on Environmental in LabVIEW following by the syllabus in orders.